Comments on: Extracting 2D mendel outlines using OpenSCAD

By: laser cut gears and pulleys « amk – lasers, RepRap…

laser cut gears and pulleys « amk – lasers, RepRap… — Wed, 25 May 2011 21:42:34 +0000

[...] of each of the three different profiles in the pulleys (3 different heights) and the gears (see GilesBathgate’s blog). The first ones weren’t strong enough so I increased the base size and used drilled holes [...]

By: Giles Bathgate

Giles Bathgate — Wed, 27 Apr 2011 21:49:32 +0000

Worked fine for me. You must be sure to press F6 (i.e. compile and render using CGAL) It will also take quite a long time: Total rendering time: 0 hours, 18 minutes, 53 seconds. Here is the results: http://www.gilesbathgate.com/y-chassis2_2.dxf

By: ivom

ivom — Tue, 26 Apr 2011 18:56:11 +0000

For some reason don’t succeed in exporting an STL file with the projection trick you outline. All I get are some 20 lines of headers in the dxf. What might I be doing wrong?

I am using OpenSCAD 2011.04.03 and the file present throuh svn at https://reprap.svn.sourceforge.net/svnroot/reprap/trunk/huxley/Cut-sheet-parts/y-chassis2_2.stl

By: 2D Mendel Outlines mit OpenSCAD « roboticexperiments

2D Mendel Outlines mit OpenSCAD « roboticexperiments — Mon, 18 Apr 2011 17:22:38 +0000

[...] mal danke an Alan aus dem RepRap-Forum der mich auf diesen Blogeintrag aufmerksam [...]

By: JF

JF — Mon, 18 Apr 2011 16:43:44 +0000

Thanks, thats exactly what I needed!

By: Spacexula

Spacexula — Wed, 23 Jun 2010 18:46:18 +0000

Ok dude, your awsome!